<form id="vrefx"></form>

    <nobr id="vrefx"></nobr>

    <nav id="vrefx"><listing id="vrefx"></listing></nav>

    • 18764172899
      0531一85977876

    • [field:companyname]
      全國咨詢熱線
    當前位置:首頁 - 新聞資訊 > 常見新聞 >

    斷橋鋁門窗設備組角機的日常維護

    來源:http://www.thinkgreeninitiative.com/ 發布時間:2022-03-07
    第一,組角機液壓系統方面。
    First, the hydraulic system of the angle machine.
    1、油泵的工作介質為液壓油,冬季使用L-HM32液壓油。夏季可使用L-HM46液壓油。
    1. The working medium of the oil pump is hydraulic oil, and l-hm32 hydraulic oil is used in winter. L-hm46 hydraulic oil can be used in summer.
    2、油箱的液面保持在油標的中心線上,以防油泵吸空,加油時應用120目濾網濾去新油中的雜質。經常使用時,一般每兩個月清洗一次油箱,濾油器半年清洗一次,同時更換新油。
    2. The liquid level of the oil tank shall be kept on the center line of the oil standard to prevent the oil pump from sucking empty. During refueling, 120 mesh filter screen shall be used to filter out the impurities in the new oil. When it is often used, the oil tank is generally cleaned every two months, the oil filter is cleaned every six months, and the new oil is replaced at the same time.
    3、正常工作油溫為20℃-50℃,油溫過高時,需要采取冷卻措施或停泵,待油液充分冷卻后才能正常工作。油溫過低時,不允許直接工作,需采取加溫措施,可通過外加溫或低壓運轉來提升油溫。
    門窗加工設備
    3. The normal working oil temperature is 20 ℃ - 50 ℃. When the oil temperature is too high, cooling measures need to be taken or the pump needs to be stopped. It can work normally only after the oil is fully cooled. When the oil temperature is too low, it is not allowed to work directly. Heating measures need to be taken. The oil temperature can be increased by external heating or low-pressure operation.
    4、泵的工作壓力不準任意提高
    4. The working pressure of the pump shall not be increased arbitrarily
    5、高壓膠管長期使用,由于膠管的老化,各處的損傷會造成膠管耐壓強度的降低,應注意定期檢查。
    5. The high-pressure hose is used for a long time. Due to the aging of the hose, the damage everywhere will reduce the compressive strength of the hose. Pay attention to regular inspection.
    第二,氣源三聯體(分水濾氣器、減壓閥、油霧器)方面。
    Second, the air source triplet (water separation air filter, pressure reducing valve and oil mist).
    首先確定氣源三聯體后端接的是否為無油潤滑的元件,若是,則不得使用三聯體,而應使用二聯體。即:取消油霧器。然后根據系統壓力和所需流量選擇相應的三聯體。長期不用時,要將壓力調零。否則彈簧長久疲勞會影響壽命。如分水濾氣器為手動排水,則要定期檢查積水情況,并將積水排去。
    First, determine whether the components connected to the rear end of the air source triplet are oil-free components. If so, triplet shall not be used, but triplet shall be used. That is: cancel the oil mist. Then select the corresponding triplet according to the system pressure and the required flow. When not in use for a long time, the pressure should be adjusted to zero. Otherwise, the long-term fatigue of the spring will affect the service life. If the water distribution air filter is drained manually, the ponding shall be checked regularly and drained.
    使用中應給分水濾氣器及時放水,保證氣體干燥;使用中應注意油霧器油量,油量不足時加油
    In use, water shall be discharged to the water separation gas filter in time to ensure that the gas is dry; Pay attention to the oil quantity of the oil mist in use, and add oil when the oil quantity is insufficient
    數控門窗設備http://www.thinkgreeninitiative.com專注為您提供服務,更多的精彩內容請記得持續關注我們,我們真誠為您提供服務.
    CNC door and window equipment http://www.thinkgreeninitiative.com Focus on providing services for you. Please remember to pay attention to us for more wonderful contents. We sincerely provide services for you